2.3
Notes on Transport, Storage and Handling
Encoder
• Use only the original packaging for transportation!
• If possible, use only the original packaging for storage�
SINGLEFLEX Scale Tape
•
Can be rolled up (minimum bending radius = 140 mm).
• No restrictions regarding to the length�
DOUBLEFLEX Scale Tape
• In no case the DOUBLEFLEX scale tape should be stored, transported or used when rolled up!
• Use only the original packaging for transportation!
- Lengths up to 3 m - stretched out
- Lengths above 3 m - tape laid down as a figure eight
• Use only the original packaging for storage!
• Damages to the adhesive layer between the scale tape and carrier tape must absolutely be avoided,
since otherwise the measuring properties of the DOUBLEFLEX scale tape are lost�
• Only remove the DOUBLEFLEX scale tape from the packaging on site, directly before mounting�
• Do not separate the scale tape and carrier tape from each other! Avoid any unintentional separation
of the scale tape from the carrier tape, even just partial separation�
•
Avoid radial or axial offsetting between the scale tape and carrier tape.
• If the scale tape should become partially or completely separated from the carrier tape - even
for just a very short time - simply pressing them together again will not result in sufficient
adhesion. In this case neither the operational reliability nor the metrological properties can
be guaranteed anymore. Please return the scale tape to NUMERIK JENA GmbH for repair!
Unfortunately a repair at the customer site is not possible.
• When removing the DOUBLEFLEX scale tape from the packaging, the sag must not exceed more
than 100 mm�
• After removing the greatest distance between two supports must not be more than 800 mm� Scale
tapes up to 1,200 mm must be supported approx� 300 mm from the ends and longer scale tapes
must be supported correspondingly�
!
7/58
KIT
L
-Series
