Gb - 22
First use from new
Fitting the battery in the receiver collar
- Unscrew the 4 screws of the top of CANICOM using a screwdriver.
- Insert the battery (3V Lithium CR2)
paying attention to follow polarity indicated on the battery
housing
(ref. Diagram 4). The tab is under the battery.
- A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove immediately the battery from its
housing. Check the polarity before trying again
- Before replacing the lid, check that the rubber seal is in its groove. Make sure the tab is in correct
position (inside the battery housing) to maintain water tightness.
- Screw up the 4 screws with care (do not overtighten them).
Polarity « - » of the battery
Polarity « + » of the battery
Seal
Diagram 4
Activate/deactivate the remote control
Remote control is supplied with battery fitted.
-
Activate: press the On/Off red button
( ) located on the side of the remote control
for 1 second
(ref.
Diagram.1). Indications appear on the LCD screen.
-
Deactivate: press the On/Off red button
( ) of the remote control
for 1 second
(ref. Diagram.1). The
LCD screen is off.
To increase the battery life of the remote control, we recommend you to deactivate the unit if you are not
using your CANICOM 200 for a long period.
( (
( (
Содержание CANICOM 200
