Num'axes CANICOM 200, Руководство пользователя

Страница: 25 / 95

Gb - 25
It’s up to you to use the beeper depending on the way you want to train your dog. With the beeper button
you can:
- send a sound to your dog when it is disobedient,
- draw its attention,…
It’s very important to always use the beeper button in the same way in order not to disturb
your dog.
F button: Flash stimulation
Press the «F» button to send a warning to your dog using stimulations transmitted by two contact points
located on the receiver collar for a defined length of time of less than one second.
A « transmission » symbol will appear on the LCD screen of the remote control; the indicator light on the
collar goes from flashing green to permanent red as long as you press the button.
C button: Continuous stimulation
Press the «C» button to send a warning to your dog using stimulations transmitted by two contact points
located on the receiver collar, the duration will be as long as you press the button but
limited to
8 seconds maximum .
Nota: Beeps can be associated to the stimulation by pressing first the “C” button and then the button.
« + » and « - » : control buttons
Use the “+”/”-“ buttons for rapid adjustment of the stimulation level of the receiver collar.
9 levels are available.
Level 1: very weak stimulation. Level 9: strong stimulation.
Always start with the lowest level of stimulation.
Checking/replacing battery of remote control
Performance (radio range) of the remote control may deteriorate as batteries become weak. Be
prepared to replace the battery
.
To check the condition of the battery, turn on the remote control CANICOM 200 and look at the battery
level indicator on the LCD screen. The symbols which appear indicate the following: