Numatic TTV-5565/200T, Инструкция оператора, Страница: 15 / 32

233887 / 06/11 (A05)
15
Brush pressure / Load adjustment
The brush load lever is located to the right hand side of the machine.
This option is for hard to clean patches, adding 10 kg extra pressure to the brushes.
The brush load indicator on the control display shows the pressure applied, when the
machine is being operated.
Load increases from 40 Kg (fig 24) to 50Kg When the lever is in the up position. (fig 24a)
NOTE: It is recommended this option is NOT used all the time and is for spot cleaning only.
Fig.24
Fig.24 a
NOTE: The run-time of the machine may decrease
if the load on the brushes is increased
Machine Operation
Waste water tank fill level warning light
When the waste water-tank becomes full, a red warning light will
illuminate on the operator control panel (as illustrated).
The vacuum motor will stop automatically after 5 seconds .
The waste-water tank requires emptying (see page 17).
Emergency-stop button
The TTV - 5565 is equipped with an electronic braking system.
Simply release the hand operated start / stop trigger and the machine will stop.
In an emergency, strike the emergency-stop button.
The machine will be disabled.
To reset, turn Emergency Stop button clockwise (see fig.25).
After re-setting the emergency stop button, to restart the machine, turn the
master control on/off key to the ‘OFF’ and then ‘ON’ position.
Fig.25