Numatic TTV-5565/200T, Инструкция оператора, Страница: 12 / 32

233887 / 06/11 (A05)
12
When handling and mixing chemicals.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-driers.
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
After use, ensure the chemical dosing tank is emptied, cleaned and refilled with clean water.
The dosing pipes also need to be cleaned and flushed through with clean water for at least 60 seconds after use.
!
!
!
!
Chemical dosing System
Note: always ensure that the waste-water tank is empty before lifting.
The TTV-5565 scrubber dryer has an optional automatic chemical-dosing system.
Simply fill the 5 litre chemical dosing bottle and the machine will deliver the correct mix ratio as set by the operator,
depending on the floor and cleaning conditions.
To fill the chemical-dosing bottle, first make sure the top waste tank is fully drained then, lift up the waste-water tank
(fig. 18), remove the dosing bottle, unscrew the bottle cap (fig.19) and fill with appropriate cleaning chemical, or fit your
own chemical container, reusing the original Numatic container cap. Refit dosing bottle (fig.19a) and replace bottle cap,
and carefully lower waste-water tank.
Note: The top (waste) tank is fitted with a pressure sensor that disables the machine until the top tank is closed.
The machine is now ready to be moved to the cleaning site.
Before performing the cleaning operation, place-out appropriate warning signs and sweep or dust-mop the floor
Fig.18
Fig.19 Fig.19a