Numatic ET 4045, Инструкция пользователя, Страница: 8 / 20

8
Note:
Raise floor-tool again before driving to the cleaning area.
Machine Set-Up
The TT Range are all equipped with a 40 litre clean-water tank allowing large areas to be cleaning in a single fill.
To fill the clean-water tank, use the FLEXI - FILL pipe from either a tap or hose pipe (Fig.12).
The large cap on the left can be
removed for filling from a bucket
or suitable container (Fig.13).
Fill the clean-water tank to a
maximum of 40 litres, including
cleaning chemicals if required.
Follow chemical manufactures
guide lines.
Note:
Great care must be taken to ensure that contaminants (leaves,hair, dirt, etc) are not allowed to enter the
clean-water tank during the filling process. If using a bucket or similar, ensure it is always clean and free from debris.
Filling the clean-water tank
Refit vacuum hose to the Floor-tool when finished.
The vacuum hose has a U-bend clip which creates a U-bend in the hose preventing water spillage when the vacuum is
switched off. If you need to remove the U-bend clip for any reason always ensure it is refitted correctly before you resume
operation (Fig 36-39).
30mm
MAX
Fitting the Hose Guide
Note:
DO NOT push the vacuum hose onto the Floor-tool with the Floor-tool in the raised position.