Numatic ET 4045, Инструкция пользователя, Страница: 7 / 20

7
Safety gloves are recommended for the changing of used brushes.
Fitting the brush
Featuring the Nulock brush system.
The brush is simply pushed and twisted to lock, making fitting and removal a simple process.
The Pad is retained using Numatic’s own PadLoc system (ask your supplier for details).
Only use manufacturer supplied brushes / pads.
TT 4045 requires a 450mm brush or a 400mm pad.
TT 4055 requires a 550mm brush or a 500mm pad.
Fit the brush / pad to the drive chuck, twist to
lock the brush (Fig.5) / pad in place (Fig.6).
ALWAYS ENSURE THAT THE MACHINE IS SWITCHED OFF
BEFORE MAKING ANY ADJUSTMENTS
! !
Tipping the Brush Deck
To tip the deck into the down position
(Operating mode). Press in the brush deck
locking pin (Fig.7) and rotate the brush deck
(Fig.8).
To change to brush deck up position,
(Transit mode) simply lift the deck and the
sprung loaded locking pin will activate to
hold the deck up.
Machine Set Up
Fitting the Floor-tool
The floor-tool has been designed for quick fitting, allowing easy squeegee blade replacement and a safety knock-off feature
if the floor-tool gets snagged, whilst in transit.
Raise the floor-tool for transit or lower for cleaning operation using the lifting
handle fitted to the back of the machine (Fig.11).
For fitting the floor-tool blades (See Page 13).
Note:
It is easier to fit the floor-tool if the weight of the machine is resting on the brush. Ensure the brush is fitted first.
Fit the floor-tool and retain using the
detent pin (Fig.9).
The lifting strap is held by a detent
pin (Fig.10).
5 6
7
8
9 10
11