Numark 5000FX, Быстрый старт руководство пользователя, Страница: 10 / 48

10
SPECIFICATIONS
Inputs
Line: 10Kohm input impedance
83mV rms sensitivity for 1.22V output
Mic: 600 ohm input impedance unbalanced
1.9mv rms sensitivity for 1.22V output
200mV rms max input
Phono: 47Kohm input impedance
1.3mV rms sensitivity @1KHz for 1.22V output
Outputs
Line: 6.5V rms max
Headphone: 0.5W into 47 ohm
Distortion: less than 0.01%
Signal to Noise Ratio (maximum output) JIS-A weighted
Line: Better than 82dB
Mic: Better than 80dB
Phono: Better than 72dB
Frequency Response
Line: 20Hz-20KHz ±0.5dB
Mic: 20Hz-15KHz ±0.5dB
Phono: ±1dB except for controlled attenuation of –3dB
@ 20Hz to reduce rumble and feedback
Channel Equalizer
Bass: +6/-32dB @40Hz
Middle: +6/-32dB @1.35KHz
Treble: +6/-32dB @15KH
Channel Kill: 80dB at 20Hz to 20KHz
Power Consumption
24 Watts typical
29 Watts with full headphone output
Dimensions
320mm(W)x355mm(D)x100mm(H)
Weight
6.1 kgs
Sampler
The maximum sample length is 36 seconds, total available buffer is 48
seconds, and buffer not used for sampler is used for echo, delay, scratch,
reverse, and bleep effects. The sampler will automatically stop recording
once the record time exceeds 36 seconds.
For the most effective wheel performance, occasional calibration is recommended:
1. Select the Scratch effect.
2. Move the WET/DRY (FX Mix Control) fader throughout its entire range.
3. Spin the wheel while holding the Record (FX Controls) and Single Play (“>” FX
Controls) buttons at the same time.
4. The display will show “CAL”.