Numa Patriot RC50, Инструкции по уходу и обслуживанию

Страница: 13 / 24

11/06/20 Page 9
Patriot
®
RC50
GENERAL ASSEMBLY INSTRUCTIONS
•
Assembly should be performed in a clean environment.
• All parts should be cleaned thoroughly and wiped dry before assembly.
•
Oil all parts by hand using Rock Drill Oil to insure easy assembly.
•
Coat all thread connections with a thread compound to allow joints to thread easily.
HAMMER ASSEMBLY
•
Select the larger outside diameter end of the case to be the chuck end.
•
Insert the snap ring into the groove located in the chuck end of case, making sure
it seats properly in the groove. Slip the bit bearing into the chuck end of the case.
Make sure the bit bearing is in contact with the snap ring in the case.
• Insert the bit bearing retainer o-ring into the groove located just above the bit bearing.
•
Slide the piston in the backhead end of the case. Push the piston all the way to the
chuck end. The piston should rid in the case very smoothly.
• Install the backhead o-ring in the groove located at the shoulder end of the case
thread of the backhead. Install the backhead bearing on the outside diameter groove
at the end of the case thread of the backhead.
•
Install the check valve seat o-ring in the groove on the outside diameter of the check
valve seat. Install the collection tube o-ring in the inside diameter groove of the check
valve seat.
O-RINGS / BACKHEAD BEARING
• Inspect for damage such as cracks and deformations.
•
Replace if necessary.
METERING SLEEVE
•
Inspect for cracks.
•
Measure OD and always make sure it is a minimum of 1/8" (3 mm) under the bit size.
• Replace if necessary.