- 2 -
2. Precaution
for
Safety
This machine is designed and manufactured for parts feeding equipment based
on the concept of trouble-free operation and labor saving. However, the user is
also responsible for ensuring safety. Read this manual carefully before starting
use, and be sure to follow the description below on safety. Also be sure to
follow the warning and caution label attached to the body.
WARNING
Indicates a potentially hazardous situation which, if not avoided, will result
in death or serious injury.
CAUTION
Indicates a potentially hazardous situation which, if not avoided, will result
in minor or moderate injury or property damage only.
WARNING
The most dangerous part of the machine is electric equipment. Be sure to connect a
grounding wire. Failure to do so may result in electric shock.
Never use the machine in the atmosphere of explosive gas or flammable gas, or in a wet
place. Explosion or fire hazard may be caused.
CAUTION
Do not use the machine in a place exposed to splash of water, outdoors, or in a place of
extremely low temperature or high temperature and high humidity. (See the next page for
operating environmental conditions.)
y
This machine is a heavy material. (See the specification in Section 10 for the mass.) In
transporting the machine, wear safety shoes, watch out for dropping, and take due care.
y
Fix the machine securely after installation.
y
Do not conduct the installation and assembly work with bare hands.
y
As for a bowl equipped with alignment mechanism, pay attention to sharp edges and do
not touch with bare hands. Be sure to wear gloves.
Do not use the machine on a base lacking in sufficient strength or in an unstable place. The
specified performance of the machine may not be observed.
Do not place the body in inclination. The specified performance of the machine may not be
observed.
Please do not scratch, pull or forcibly bend the wiring. Moreover, when a heavy thing is put
on it, or it is pinched, the wiring will damage. It causes a fire or an electric shock.
When welding the machine to a bowl, be sure to connect the grounding clip of welder to the
bowl. If welding ground is insecure, the grounding wire connecting between the body and
the controller may be burnt, resulting in electric shock or leakage.
