NTI VEEMUX VIDEO MATRIX SWITCH
36
Buttons
The IRT-UNV Infrared Remote Control user interface consists of a keypad with 29
buttons. The buttons have the following functions:
•
Numerical Values (0-9)
Selects port numbers (for IN, OUT)
Selects memory locations (for saved configurations)
•
* (Asterisk)
Pressed to select all outputs
•
OUT
Pressed to indicate an output port selection
•
IN
Pressed to indicate an input port selection
•
IN + / -
Cycles through input ports (up or down), connecting to each one (similar to
changing channels)
Note: This affects only the selected output port
•
SAVE
Pressed to save the current switch configuration (port connections and
volume settings)
Up to 10 configurations can be saved (0-9)
•
RECALL
Pressed to recall a switch configuration (port connections and volume
settings)
Up to 10 configuration can be recalled (0-9)
•
SYS
Pressed to select the desired NTI system to be controlled
Only used when controlling multiple systems
Must be followed by a system number: 1-15
•
ENTER
Pressed to immediately accept the command (normal delay is approx. 5
seconds).
•
ESC
Pressed to cancel the current command
Note: If the command has not yet been accepted, all button presses in the
command sequence will be cleared
•
Standby
Pressed to put the unit into or out of standby mode
•
VIDEO
Pressed prior to entering a port switch command
Applies the command to the video signals only
(by default, port switch commands are applied to both Audio and Video)
•
BLANK Video
Turns OFF Video for the selected output
Can be used with *(Asterisk button) to turn OFF video for all outputs
Video will be turned ON by pressing the Blank Video button again, or by switching ports
Note: Blank and Un-Blank commands are applied only to the selected output
