7
A
UTO-DIALER OPERATION
Power ON
Self-
T
est:
The Dialer will perform a self-test checking signal connection when powered ON. After the self-test, if a connection is
made the number on the display will indicate the signal strength (1 = weak, 5 = strong), the decimal point at the lower
right corner on the 7 segment display will blink slowly and the dialer will be ready to work.
Note: If no signal is found, the decimal point will blink rapidly and "0" will be displayed.
If configuration (phone numbers and voice message) already exists, the AUTO-DIALER will alarm automatically upon
receiving an alarm signal. To setup or change the configuration, please follow the procedures below to save and check
telephone numbers and passwords as well as to record and play back recorded voice message:
1. Log into the Programming Mode:
First press
P
AUSE
, then put in the Private Password (4 digits), then press
ENTER
Note: The Default Password is
0
911
For instance: Log into the Programming Mode as follows:
PAUSE 0911 ENTER
If the password you entered in is correct, the LED will display "
5
", and then log into the Programming Mode,
If the password you entered is incorrect, the LED will display “E
”
and return to the working mode. Repeat the
procedure to try again.
2. Program and
Check
SMS
C
enter
N
umber
If you do not program the SMS Center number (your carrier's connection number) after powering ON the dialer, it will
automatically obtain the number by default.
We recommend to allow the dialer to automatically obtain SMS center number in normal use.
To view the current SMS Center number: Under programming state (in
“
5
”
state): press
“
3
”
and
“
0
”
; the dialer will display
the SMS Center number, and user will hear a tone
“
Du
”
. If the number is not correct, perform the following to change it:
Under programming state (
"5
"
on the display): press
“
0
”
and then input SMS center number, and press
“
ENTER
”
. (You
will need to get this number from your carrier if the dialer does not obtain the number automatically)
For example: 0+18965713028=ENTER.
The dialer will display
“
∩
”
if it receives a correct input.
To delete the SMS center number: under programming state, press
“
0
”
and then
“
ENTER
”
. The dialer will display "
∩
”
if it
receives a correct input.
Содержание E-AVDS-4G1
Страница 5: ...5...
