3
2.3) Setting HC10B to combined room and floor sensor
Note: This setting is used when using the heating under a timber floor
Press [
] for approx. 4 secs.
(FL), (RO) or (CO) will flash on the display.
Press one of the arrow key
s [▼] or [▲] until (CO) shows on the display.
Confirm by pressing [OK].
The thermostat is now set to combined floor and room sensor.
The choice of combined room and floor sensor activates monitoring of the temperature in the floor. Temperature monitoring is set at
the factory to max. +27
o
C and min. +15
o
C.
By using the floor sensor, HC10B will now ensure that the floor temperature
#)
is never higher than + 27
o
C nor lower than + 15
o
C.
These values can be adjusted as desired.
#
)
Temperature measured by floor sensor
.
Limiting the maximum temperature in the floor is important when the heating is installed under a timber floor. Leading suppliers of
timber floors prescribe a maximum temperature of 27
o
C on the surface of their floors.
Find out what the supplier of your timber floor recommends. Set the maximum value to the prescribed temperature.
3) Night and day setback settings
3.1) Setting HC10B to operate night and day setback.
Press [P]
PROGRAM will flash
Press [OK]
HC10B will now operate night and day setback
3.2) Changing between night and day setback programs 1, 2 or 3
Press [P]
Program on the display will flash
Use [▼] or [▲] to set the desired Program
Exit by pressing [OK]
3.3) Read the current settings
Press [P]
Press [P]
Current weekday(s) will flash.
Use [▼] or [▲] to choose day(s)
Press [P]
The time zone setting on the display will flash
Use [▼] or [▲] to view the time zone time and temperature incl. Max. and Min. settings.
Exit by pressing [OK] and [OK]
3.4) Changing time settings for night and day setback
Press [P] followed by [▼] or [▲] to the program you wish to change; the display will flash.
Press [
]
The hours on the time display will flash
Use [▼] or [▲] to set the hour figure.
Press [
]
The minutes on the time display will flash
Use [▼] or [▲] to set the minute figure.
Press [OK]
The selected Time zone will flash.
Use [▼] or [▲] to select the program you wish to change next.
or
Exit by pressing [OK] and [OK].
3.5) Changing temperature settings for night and day setback
Press [P]
PROGRAM will flash
Press [▼] or [▲] to the program you wish to change; the display will flash.
Press [
]
The temperature will flash
Use [▼] or [▲] to set the temperature.
Press [OK]
The selected Time zone will flash.
Use [▼] or [▲] to select the program you wish to change next.
or
Exit by pressing [OK]
4) Override
4.1) Temporarily override the temperature
with “Econ” or “Comf”
If the time zone is in
“Leave” or “Sleep” the override will go into “Econ” and lover the temperature until the next time zone gets
active.
If the time zone is in “Wake” or “Home” the override will go into “Comf” and raise the temperature until the next time zone gets
active.