17. Closeup picture of the Purple, Blue,
White Patch connection to headlight
motor and Plug. (Figure 19)
18. Non DRL SR5 Base Model
Headlights 014-2017: No cutting of
blue wire needed on our NSV
Patch Harness connected to
Headlight housing. DRL & LED
Headlight Version Models 2014-2019:
You will need to only cut the blue
wire as shown in picture.
Note: You can only cut the blue
wire from the NSV Patch con-
nected to the headlight housing.
If you cut anywhere else this will
cause lightbar operation issues.
Fig 19
Fig 20
Fig 21
Fig 22
10mm Bolt
19
.
Remove two 10mm bolts in order to
drop the bottom drivers dash panel.
(Figure 21)
Warning:
Do not pull on the SRS Airbag
dash panel, this panel is to be left alone.
Lower Dash panel removes without SRS
airbag panel.
20. Using a Plastic Trim Pry Tool work
around the drivers dash panel to pop
clips out. The red and white circles
are where your pop clips are holding
the lower dash panel together.
(Figure 22)
Warning:
Do not pull on SRS Airbag in
the lower dash panel, this panel is to be
left alone. Lower Dash panel removes
without SRS airbag.
SRS Airbag
