12. Route the harness with 12 loose
pins, tape them together with
electrical tape and route the wires
through the hood, as shown. There
are two holes; use the closest one to
your vehicles firewall. (Figure 13)
11. Pull through 12inches of harness
through the firewall from interior into
the engine bay. Connect the wires
into the 6pin black connector. There
are numbers on the connector that
correspond to the numbers on the
wire harness; populate the connector.
(Figure 11 & 12)
Fig 11
Fig 12
Fig 13
13. Pull 55inches of harness through
with your left hand while feeding the
slack with your right. (Figure 14)
Fig 14
