IPCAM User Manual
63
computer can run normally but IPCAM can’t, Please press heavily when making the cable connector.
2. Confirm the power supply normally. First, check whether power indication
light turn on or not, If it is on,then check the yellow light on RJ45 Port
(power indication light) and green light (network indication light) are on or
not.If they are on,so power supply and cable runs normally.
3. Confirm all the firwall and antivirus software are close.The firewall often
block unrecognized data so if the firewall is running ,so maybe the IPCAM
TOOL can’t find the device.Suggest to close firewall and antivirus
software temporarily before searching.
How to solve the camera blank screen?
1. Check if you are using the wrong power adaptor.please use original one.
2. Close antivirus software.
How to solve the camera can’t login by Internet?
1. Check if you set DDNS success or not?
2. Check the current IPCAM’s port number is the same as router’s?They need to keep same.
Can’t view the monitoring picture
1. Reason: can’t connect with network
Solution:Check if the network connect well, exclude cable fault and PC virus
cause network fault until can be used between PC and PING.
2. Reason:IP address occupy by other device
Solution: Choose automatic gain
3. Reason: IP address located within different subnet
Solution: Check IPCAM’S ip address and subnet mask address and gateway settings.
4. Reason:Web port has been modified
Solution:contact network administrator to obtain port information.
5. Reason:unknown
Solution:Press reset button to factory default state,then reconnecting.systen
default to gain ip address automatic,subnet mask is 255.255.255.0
8.5 Default Parameters
·
Default network Parameters
IP address
: dynamic obtain
Subnet mask
:255.255.255.0
Gateway
: dynamic obtain
DDNS
: Factory provide
·
Username and password
Default administrator username:
admin
Default administrator password :
No password
