Plug the charger cord into an electrical outlet
(120 VAC).
Let the battery charger charge the battery until the
green LED is lit.
See Battery Charger section for more details.
Preparing the Solution Tank:
Make sure the filter basket is in place to keep debris
from getting into the solution tank.
Fill solution tank to the desired level.
Add chemical following the directions provided on the
chemical bottle label.
The solution tank will hold 4 gallons (15 liters).
ALWAYS
follow the chemical manufacturer’s
instructions printed on their product’s label.
Installing the Spraying Wand Assembly:
Connect the wand assembly to the shut-off valve.
Connect the spray nozzle to the wand assembly.
Tighten all connections to prevent leaks.
Operating the Machine
Plug the charged battery into the machine.
WARNING:
only use the 24V Lithium ion battery
provided or replacement purchased from NSS
Enterprises, Inc. Use of any other battery can result in
serious harm or injury to the operator and series
damage to the machine.
Priming the pump:
Remove the top cap to the solution tank.
Turn on the power switch.
Spray solution back into the solution tank to prime the
pump.
Close the shut-off. Pump should stop running.
Replace the top cap to the solution tank.
Begin spraying.
MACHINE MAINTENANCE
Routine maintenance is critical to ensure proper
machine operation and cleaning performance. Perform
all maintenance procedures as follows.
Always turn OFF all machine switches before
performing any maintenance.
Daily Maintenance
Battery Charging
Recharge the battery after every use.
Battery charge should take 3.5 to 4 hours from fully
depleted.
When not in use, battery should be left connected to
the battery charger.
Solution Tank
Empty and clean the solution tank after use.
Empty and rinse out the filter basket as required.
Weekly Maintenance (20 hours)
Verify all daily maintenance has been performed.
Flush solution tank and spraying wand assembly with
water. Check for leaks in the connections.
Repair or replace any worn or damaged components
as needed.
Inspect spray pattern at the spray nozzle. Clean out if
necessary.
Machine Storage
Always remove the battery from the machine and put on
charge prior to storing the machine.
The machine should be stored out of direct sunlight in
a cool, dry place.
If exposed to freezing temperatures, make sure to
drain all liquid from the solution tank, pump, hose,
and spraying wand assembly.
Lock the shut-off valve in the “open” position.
