GENERAL INFORMATION AND WARNINGS
•
This NSS machine is are delivered with the
SPE CBHD1 24-5 battery charger set for
35AH AGM batteries.
•
Electronic automatic battery charger with
microprocessor suitable for differnt battery
types. See Battery charger manual included
with this machine for details.
•
Fully automatic charging cycle with electronic
settings; protected against overload, short-cir-
cuit at clamps and reversed polarity.
•
Before starting to charge, make sure the
voltage of the equipment suits the voltage of
the battery, that the charging current suits the
capacity of the battery and that the select-
ed charging curve (for lead-acid batteries or
airtight gel batteries) is correct for the type of
battery to be charged. In addition, make sure
the rated input voltage of the charger suits
the available supply voltage and the system
is equipped with grounding.
•
Pay attention to any remarks of the battery
manufacturer.
OPERATING PRINCIPAL OF THE CBHD1 24-5
When powering up the battery charger it will
display either the flashing Red LED or Green
LED for 5 seconds while it checks the AC input
voltage and the DC battery voltage and decide
whether or not to start the charging process.
Flashing Red LED at start up indicates one of the
two WET charging curves.
Flashing Green LED at start up indicates one of
the two AGM/GEL charging curves.
If the battery is not connected to the battery
charger or if there is an anomaly, the Yellow LED
will flash. If the result is positive after 1 second,
the charging of the battery will start with the Red
LED on. The output relay closes and the cur-
rent of the first phase rises slowly until the pro
-
grammed nominal value is reached.
If the user disconnects the battery from the
battery charger during charging, the Red, Yellow
and Green LED’s will be on for 1 second. After
that, the battery charger will reset.
The progress of the charging process is shown
by three LED’s: Red, Yellow and Green as typical
for the battery charger product range. The Green
LED indicates the end of the charging or the last
phase in the case of a deep charging process.
When charging is finished, the relay is opened to
disconnect.
OPERATION INSTRUCTIONS
•
Plug the cord into a socket.
•
The charging cycle progress will be shown by
Red, Yellow and Green LED indicators. At the
end of the charge, when the green indicator
is on, unplug the cord from the socket and
operate the machine.
Battery Charger Operating Instructions – SPE CBHD1 24-5
Front label on Battery Charger SPE CBHD1-XR-P
Red LED Yellow LED Green LED
