4
ENGLISH
GERMAN FRENCH SP
ANISH IT
ALIAN
5
1. Connecting / Disconnecting the Handpiece
(1) Connecting
Push the handpiece on to the motor taking care to keep
it in alignment. Twist the handpiece until it locks into
position with a clicking sound. (X-SG20L/SG20,
X-SG25L, X-SG93L/X-SG93)
(2) Disconnecting
To disconnect, hold the motor and the handpiece, and
pull out it straight.
CAUTION for X-SG93L/X-SG93
· Do not use the motor which runs at up to 400,000min
-1
.
· Do not use long surgical burs. Do not use burs longer than 26mm. The shanks of longer burs may warp under.
· Always use irrigation water during the operation. Head may overheat because of the high speed rotation.
· Even if it do Irrigation and use handpiece, bearing is worn and it may overheat or noise. Ask repair for your dealer.
· Do not connect or disconnect handpiece until the drive motor has completely stopped.
· Connect only the motor which has max rotation speed is less than 40,000min-1 with E type joint (ISO3964)
· Connect only NSK’s Motor or motor that it have stopper pin.
· This product’s joint followed ISO3964 standards.
CAUTION
CAUTION
Fig. 1
Handpiece
Motor
Motor Insert
001
