NSK PDV30, Руководство по эксплуатации

Страница: 7 / 12

Page 7 of 12
Working with the foot switch
Before switching on the device, connect the foot switch on the right side of the device.
Afterwards, switch on the device:
Following this, you can switch the motor on and off by operating the foot switch.
Press the foot switch in order to switch off the activated tool and the suction system. Press the
foot switch again. The grinder and the suction system are switched on again.
Tool change:
In order to change the tool,
the speed has to be switched off . Press the Start/Stop
pushbutton (7) to that end. Wait until the tool stops.
Pull out the tool and then set a new one.
The tool has to be pushed into the tool holding fixture until the stop point in order to
prevent any loosening during operation.
Only use grinders with a maximum diameter of 6 mm.
Only use diamond grinders.
After that, press the Start/Stop pushbutton (7). The grinder and the suction system are switched
on again at this point.
Separate switching on and off of the suction system:
Press the ON/OFF pushbutton VACUUM (13) for the suction system.
The suction system is switched off. The grinder continues to operate.
Press the ON/OFF pushbutton VACUUM (13) for the suction system once again in order to switch
the suction system once again.
Switching off the device:
Press the I/O pushbutton (5). The device is now in the standby mode. Switch the main switch
on the right side of the device off in order to switch the device off completely.
General notes:
Please only insert dry and dust-free grinders into the hand-piece.
Never exert manual pressure and do not carry out any upward or downward movements – only
sideways movements are permitted - while grinding so that the grinder cannot become
detached from the hand-piece.
Do not touch rotating tools. Risk of injury!
For your own safety you should wear gloves, protective goggles and breathing protection during
treatment.
If the hand-piece falls down, interrupt your work immediately and have the device checked by
an authorised dealer in order to avoid further damage.