SETUP
Microplex outputs
The two microplex connectors located on the back panel of the NCM 6200 controller are both outputs and will not
accept any input signals. Both male and female connectors are provided and can be used simultaneously. These
outputs are to be used with any standard 3-PIN microphone cable to connect the NCM 6200 to your NSI Dimmer
Packs. This link provides power to the NCM 6200 via the Dimmer Packs (pin 1: ground, pin 2: +15v DC) and also
serves to send the microplex dimmer signal to the Dimmer Packs (pin3).
System hookup
The microplex outputs eliminate the need for AC power directly into the NCM 6200 Controller, making placement
easy and convenient. You need only connect a single three-conductor audio cable (standard microphone cable
with XLR's) to one of the Microplex output ports on the back of your console. The single cable will carry all of the
control signals to your dimmer packs at the stage. In most cases, you can even use one channel from an audio
snake to provide the link between Controller and Dimmer Packs, thus eliminating an individual run of microphone
cable.
NOTE
It is recommended that when using satellite type Dimmer Packs, at least two (2) operational dimmer packs be
used to power the NCM 6200 Controller. Using only one Dimmer Pack may result in insufficient power and erratic
operation.
Long control cable runs over 150ft may require the use of at least 18GA shielded cable or an additional power
supply located near the console.
Configuration
Your NCM 6200 comes configured with standard softpatch and 16 dimmer output. If changes are required for your
application, please see the section on Configuration Modes.
IMPORTANT
If this Is the first time you are using the console or if you experience any problems such as dimmers not
responding or other unusual operation, the configuration may have been accidentally changed. You can quickly
reset it to factory default as follows:
Remove the microphone cord, hold the Blind and Blackout buttons down while reconnecting the cord. This will not
erase your scene memory but will reset all configuration functions.
CONTROL FUNCTIONS
Channel Levels
The Channel Level Controls are used to vary the output levels of the 16 individual control channels. These levels
can be used in programming memory scenes, flash scenes, or chase steps. They can also be used to directly
control the levels output to stage.
