6
AUDIO SYNC
An audio signal may be supplied to the NCM 1600 console via the 1/4" phone jack
located on the back of the unit. The audio signal can be used to synchronize the chase
to the beat of the audio and to affect the intensity of predetermined channels.
To synchronize chase, activate the audio mode by tapping the Audio button until the
LED above it lights. Now activate a chase pattern and move the Chase Rate control to
the minimum position. Move the Audio Sensitivity slide control slowly up until the
desired effect is achieved.
Programming audio intensity effects
The Audio mode may be programmed to flash desired channels to the intensity of the
audio signal whenever the Audio mode is on by following these steps.
1. Tap the Program button until the LED above it lights. If the LED does not light the
memory lock is on.
2. Select channels to be affected by audio by moving the corresponding channel level
sliders to maximum, and move the remaining channel level sliders to minimum.
3. Tap the Audio button to program the audio intensity effects into memory.
REAR PANEL DIP SWITCH SETTINGS
The 4 DIP switches on the rear panel serve special functions as follows:
1
MEMORY ACCESS
ON (DOWN)
OFF (UP)
= LOCKED
= UNLOCKED
2
RESERVED
3
CONFIGURE TAP BUTTON ON (DOWN)
OFF (UP)
= MANUAL TAP
= TAP SYNC
4
CONFIGURE ACCESS
ON (DOWN)
OFF (UP)
= LOCKED
= UNLOCKED
