Zone fade time programming.
Each zone may be programmed with an individual fade time. This is the time it will take the dimmer channels
assigned to go from full off to full on and visa versa. Fade time can vary from 0 to 13 seconds. A longer fade
time will increase the accuracy when using the increase and decrease buttons to set desired lighting levels. A fade
time of 0 seconds will cause instant full on or full off operation whenever the increase or decrease buttons are
pressed. If the factory default setting of 5 seconds is desired for each zone then this step may be ignored.
To program zone fade time:
1.
Make sure that the 400CP is in the program select mode as discussed.
2.
Press the zone 3 increase button to enter "fade time mode"and the BUSY LED will stop flashing.
3.
Select the desired zone by pressing the associated button as shown in the diagram.
4.
Press button marked with desired fade time in seconds.
5.
Unit will exit this programming mode after the release of the button and the BUSY LED will start flashing
again.
400CP REMOTE CONTROL PANEL
PROGRAMMING
Software Revision 3.00, Version C
Zone fade time programming.
NSI CORPORATION
7
