10.
WARNING: Fire Hazard
The connection of the cables to the power source must be positive to positive
(red clamp to battery “+”) and negative to negative (black clamp to battery “-“).
A reverse polarity connection may cause damage to the unit and/or create a
sparking/explosion hazard.
To recharge with the jumpstart clips:
1. Ensure that the jumpstart power switch is “OFF”.
2. Connect the red positive (+) clamp of the cables to the positive (+) terminal of
power source.
3. Connect the black negative (-) clamp of the cables to the negative (-) terminal
of power source. If the red “Reverse Polarity” LED illuminates, then reverse
polarity has been detected. Correct polarity must be established before
proceeding. Disconnect the jumpstarting clamps from the vehicle’s battery and
do the steps 2 and 3 again.
4. Turn on the jumpstart power switch.
5. Turn on the power source to charge the battery.
Features:
Input voltage: 13.5V
Input current: 2A (recommended)
Protection: No
Charging with the DC to DC charging cable with 12 V Power outlet (the
DC-DC cable is not included)
CAUTION:
When using the DC-to-DC charging cord, there is no automatic
overcharge protection once the battery is fully charged. Do not leave the unit
connected without supervision. Detach the DC-to-DC charging cord from the
unit and the vehicle as soon as the battery is fully charged or if the vehicle’s
engine is turned off. Do not leave the jumpstarter indefinitely connected to the
vehicle’s 12 V accessory outlet.
WARNING: Fire and Explosion Hazard
Do not use this recharging method if your vehicle’s electrical system operates
above 15V. This may lead to accumulations of hydrogen, causing exposure to
fire and explosion hazard. This condition is typically found in marine appliances
or portable generators with DC output.
