8.
The procedures to jump start a vehicle:
(1). Turn off the vehicle and all accessories.
(2). Place the NPOWER Jumpstarter on a flat and stable surface near the
battery which need to be started. Ensure that the Jumpstart power switch is
“OFF”.
(3). Connect the red positive (+) clamp of the cables to the positive (+) terminal
of the engine battery.
(4). Connect the black negative (-) clamp of the cables to the engine block,
cylinder head, or other stationary heavy metal part of the motor. If the red
“Reverse Polarity” LED illuminates, then reverse polarity has been detected.
Correct polarity must be established before proceeding. Disconnect the
Jumpstart clamps from the vehicle’s battery and do the steps (3) and (4) again.
(5). Switch on the Jumpstart power switch. Before starting the engine, make
sure the Jumpstarter and the cables are clear of the metal parts and other
moving things.
(6). Crank the engine for 5 seconds or until it starts, whichever is first.
WARNING: Fire hazard
Do not crank the engine for more than 5 seconds. The Jumpstart feature is
designed for short term operation only. Operating the Jumpstart feature for
more than 5 seconds may cause damage to the unit. Allow the NPOWER
Jumpstarter to cool down for at least 3 minutes after each boost.
(7). Switch off the Jumpstart power switch.
(8). Remove the red positive (+) clamp and then the black negative (-) clamp
from the engine battery.
6. RECHARGING
WARNING:
Do not charge the unit in wet or moist locations because it may cause severe
electric shock and injury may result.
WARNING:
Do not charge the unit immediately after any severe discharge or heavy usage.
Wait half an hour to let the battery of the unit cool down first.
