MTC-20/2S User Manual
_______________________________________________________________________________________________________________
(10) COMMAND INPUT 10mV/°C
connector
BNC connector to set the working temperature of the controller system by an
external voltage signal. This input is scaled with the factor 10mV / °C.
(11) SENSOR A / SETPOINT / PWR OUT switch (
display mode switch)
Switch to select the mode of display A (
2
):
SENSOR A (upper position):
the temperature determined by SENSOR A
(
13
) is displayed (XX.X °C)
SETPOINT (middle position):
the
value preset at the DESIRED
TEMPERATURE
potentiometer (
1
) is displayed (XX.X °C)
PWR OUT ( (lower position): the voltage at the POWER OUTPUT (
18
/
19
) is displayed.
(12) OUTPUT A 10mV/°C
connector
BNC connector monitoring the temperature determined by SENSOR A (
13
),
sensitivity: 10mV / °C.
(13) SENSOR A
connector
8-pole connector for temperature SENSOR A.
This connector also provides the POWER OUTPUT (
18
/
19
) for the heating unit
(max. 12V DC and 1A) for devices with the ALA DIN connector cable assembly.
(e.g. HPT-2A, see www.alascience.com).
(14) MODE
switch
Switch to select the operation modes of the MTC-20/2S. Four modes
are available:
SENSOR A: the temperature determined by SENSOR A (
13
) is
used for the control system
DIRECT:
the voltage at the POWER OUTPUT (
18
/
19
) can be
set directly from the DESIRED TEMPERATURE
potentiometer (
1
) (0-12 V, no control)
EXT. SENSOR (EXTERN SENSOR): an
external
thermometer
connected to BNC (
15
) (sensitivity 1mV/°C) can be
used for the controller loop
SENSOR B: temperature determined by SENSOR B (
16
) is used as
feedback temperature in the controller loop.
___________________________________________________________________________
version 2.7
page 7
