GyroSet Link Wiring to PGDT
The
GyroSet Link
provides a proportional analog signal compatible with the PGDT Omni (and
some other controller systems – see in System Requirements). The interface is a standard
D-type connector, fitted with “detect link” and “fifth switch” functions. As there is no internal
power source or auxiliary power input connector on the GyroSet Link the power for operation is
provided by the Omni.
If the Omni is configured with the programmable parameter “Sleep 12V” to cut the power on SID
connectors when turned off, GyroSet Link is going to be turned off as well. GyroSet Link doesn’t
require a permanent power supply. For power saving reasons “Sleep 12V” parameter is advised
to be set in the R-Net system.
On the GyroSet Link there are two connector interfaces. One of which is an integrated cable
with a D-type connector on it to control the Omni (referred to as Omni cable) and another
oval-shaped interface to connect the GyroSet Glory cable (referred to as Data cable).
Omni Port-1 D-type connector
The two interfaces of the GyroSet Link
(on the left oval shaped data connector)
The preferred SID port, if there is only one input device connected to the Omni, is Port 1 as
shown in the picture below. In case of PGDT IOM there is only one INPUT port where the
D-type connector can be connected:
Содержание GyroSet Cubo
Страница 9: ......
