Novus NVR-6432-H2/F, Быстрый старт

Страница: 7 / 60

NVR - 6432 - H2/F
User ’ s manual (Short) ver.1.1
All rights reserved © AAT Systemy Bezpieczeństwa sp. z o.o.
7
STARTING THE DEVICE
After removing the housing, mount the disk or disks using the mounting screws (4 pieces per disk). The
drives should be screwed in the places marked in the picture below
After screwing the disks, connect the signal and power cables between the disk and the recorder main
board.
2.3. Connecting the power supply.
Please connect provided power cord in the rear power port of the NVR like described
below.Initialization lasts approximately 60 seconds. During this time executing any device functions
and pressing any buttons is prohibited. To shut down the device please use the menu.
CAUTION:
Make connection when the power is not applied and the power switch is turned off.
Do not place the power cord under the carpet or rug. The power cord is usually earth - grounded.
However, even if it's not earth - grounded, never modify it on your own for earth - grounding.
Make sure that power adapter is placed near of NVR and secured from accidental disconnection.
If the device was brought from a location with lower temperature, please wait until it reaches the
temperature of location it is currently in. Turning the device on immediately after bringing it from a
location with lower ambient temperature is forbidden, as the condensing water vapour may cause short -
circuits and damage the device as a result.
Before starting the device familiarize yourself with the description and the role of particular inputs,
outputs and adjusting elements that the device is equipped with.