Novus NVR-5404POE, Руководство пользователя

Страница: 8 / 40

NVR-5404POE User’s manual (Short) ver.1.1
All rights reserved © AAT Holding sp. z o.o.
8
STARTING THE DEVICE
2.4. Connecting monitor
This product supports following interfaces for main monitor: HDMI, VGA
For HDMI and VGA outputs following resolutions are supported: 800x600, 1024x768, 1280x720
1280x1024, 1366x768, 1440x900, 1920x1080.
After changing resolution you have to confirm it by clicking YES. In case of monitor does not display
anything please wait 8 seconds, then previous resolution will be restored.
Note:
You can use the HDMI <> DVI converter to connect to the DVI monitor.HDMI cable and
HDMI<>DVI converter it’s not included and you have to buy it separately.
2.5. Camera and Network wiring
NVR-5404 POE has 4 bulid-in RJ-45 ethernet ports with PoE support which can be used for
connecting cameras (IPC1 to IPC4 ports). By using Ethernet cables connect the cameras to the NVR
and NVR to the switch, like on image below. Please notice that the Ethernet connection is effective
within 100 meter distance.
Each Network controller must have a unique IP address belonging to different subnets (similar like
for addresses IP WAN and LAN router).
Before adding any camera to the NVR, you have to configure its network settings like it is described
in Camera User Manual. For the next steps of camera and network configurations please check
chapter 3.4. Startup configuration.
NVR-5404POE
PC COMPUTER
ETHERNET
SWITCH
INTERNET
IP CAMERAS
WAN
NIC IP address Mask Usage
Network controller: 1 192.168. 1 .188 255.255.255.0 For camera connection - internal PoE switch
Network controller: 2 192.168. 2 .188 255.255.255.0
For remote clients connection - local and
Internet