NVR
-
4416P16
-
H2/F User’s manual (short) ver.1.1
All rights reserved © AAT SYSTEMY BEZPIECZEŃSTWA Sp. z o.o.
10
2.3. Connecting the power supply
Please connect provided power supply in the rear power port of the NVR.
To start the unit turn on the power switch on back panel. Initialization lasts approximately 60 seconds.
During this time executing any device functions and pressing any buttons is prohibited. To shut down
the device please use the menu.
WARNING!
Make connection when the power is not applied and the power switch is turned off.
Do not place the power cord under the carpet or rug. The power cord is usually earth
-
grounded.
However, even if it's not earth
-
grounded, never modify it on your own for earth
-
grounding.
Make sure that power adapter is placed near of NVR and secured from accidental disconnection.
If the device was brought from a location with lower temperature, please wait until it reaches the
temperature of location it is currently in. Turning the device on immediately after bringing it
from a location with lower ambient temperature is forbidden, as the condensing water vapour
may cause short
-
circuits and damage the device as a result.
Before starting the device familiarize yourself with the description and the role of particular
inputs, outputs and adjusting elements that the device is equipped with.
2.4. Connecting monitor
NVRs support following interfaces for main monitor: HDMI, VGA.
For HDMI following resolutions are supported: 1024x768, 1280x1024, 1440x900, 1280x720,
1920x1080, 2560x1440, 3840x2160. VGA supports resolution up to 1920x1080.
2.5. Connecting ethernet and IP cameras
NVR
-
4416P16
-
H2/F have built
-
in RJ
-
45 PoE ports, which can be used for direct connection up to
16
IP
cameras. Notice that the ethernet connection is effective within 100 meter distance. Using
Extended PoE mode the cable lenght might be up to 200 meters.
We recommend that you configure the camera before connecting to a recorder, as described in the user
manual of the camera. Please note that cameras have addressed the unique IP address supported by the
recorder. Recorders with built
-
in PoE switches use a different address from the cameras connected via
the built
-
in switch and another to connect to a device connected via the LAN port.
Connecting Novus IP camera 2000 or 4000 serie to PoE port results adding it to the list automatically
(if camera password is default).
STARTING THE DEVICE
