NVIP-3DN3012V/IR-1P, NVIP-3DN3013V/IR-1P, NVIP-3DN3014V/IR-1P - User’s manual
(short form) ver 1.0
All rights reserved © AAT Holding sp. z o.o.
12
4. INSTALLATION
NVIP-3DN3012V/IR-1P
1. Remove camera base by turning it counter-clockwise.
2. Use the included mounting template or the camera base plate to mark holes for mounting screws.
3. Drill holes in marked places and optionally make an extra hole for camera cables.
3. Mount the camera base to the surface using the included mounting screws (please pay an extra
attention to cable routing).
4. Fit camera into base, adjust position as needed. Then tighten the cover and locking screw.
6. Connect camera cables.
7. Adjust camera zoom and focus with small flat blade (after starting IP Camera, details in chapter 2.4).
NVIP-3DN3013V/IR-1P
1.
Remove locking screw from camera dome and then remove camera dome.
2.
Use the included mounting template or the camera base plate to mark holes for mounting screws.
3.
Drill mounting and cable holes in previously selected points.
4.
Mount the camera base using included screws on smooth surface providing declared degree of IP
protection.
5.
Adjust the position of the camera module. If required, loosen the screws blocking camera
module.
6.
Put on the camera cover again, matching screws to the corresponding holes located in the base
of the camera and screwing until slight resistance is felt. Please ensure that the mask doesn’t
block camera’s field of view.
START-UP AND INITIAL IP CAMERA CONFIGURATION
