Novus NVIP-2ATM-4401, Руководство пользователя

Страница: 7 / 32

NVIP-2ATM-4401 - User’s manual (short form) ver 1.0
All rights reserved © AAT Holding S.A.
7
1.4. Package contents
After you open the package make sure that the following elements are inside:

IP camera

230 VAC / 12 VDC power supply

Accessories bag

Short version of user ’ s manual

CD containing manual and software
If any of this elements has been damaged during transport, pack all the elements back into the original
box and contact your supplier for further assistance.
CAUTION!
If the device was brought from a location with lower temperature, please wait until it reaches the
temperature of location it is currently in. Turning the device on immediately after bringing it
from a location with lower ambient temperature is forbidden, as the condensing water vapour
may cause short-circuits and damage the device as a result.
Before starting the device familiarize yourself with the description and the role of particular
inputs, outputs and adjusting elements that the device is equipped with.
2. START-UP AND INITIAL CAMERA CONFIGURATION
Before starting the device familiarize yourself with the description and the role of particular
inputs, outputs and adjusting elements that the device is equipped with.
2.1. Description of connectors
1. Power supply 12VDC
2. 100 Mb/s Ethernet port
3. Audio in (RCA, black)
4. Audio out (RCA, red)
WARNING!
Camera and its connectors are not hermetic. Do not expose them to moisture.
2.2. Camera mounting
1. Remove the camera holder by unscrewing both fixing screws on the sides of the camera
2. Mount the camera holder in the selected place with a suitable screw or bolt
3. Place the camera between the fork of the holder and mount it with fixing screws, screwing them in so
that you can adjust it.
4. Adjust the camera position and tighten with the fixing screws
To set the preview from the camera, connect the power to the camera and then connect
with the camera using a PC.
WARNING!
The camera housing is not hermetically sealed. Do not install the camera outdoors or in places
exposed to moisture.
START-UP AND INITIAL CAMERA CONFIGURATION
1
2
3
4
fixing screw
holder