Novus LogBox-RHT-LCD, Инструкция по эксплуатации

Страница: 2 / 6

LogBox-RHT-LCD
NOVUS AUTOMATION 2/6
2.1 MEASUREMENT ACCURACY
Figure 2 – Accuracy
Figure 3 – Logger front (CH1)
Channel Indicator : Indicates the channel selected.
Battery Indicator : When the battery voltage is low, the battery
symbol will be shown.
MIN / MAX Values Indicator : Minimum and maximum value of
each channel during readings.
3 OPERATION
To use the device, you must install the NXperience software on a
PC, according to the steps described in the NXPERIENCE
SOFTWARE section.
The communication between logger and PC is performed with a IR-
Link Interface .
The logger operation mode set up is defined by using NXprience
software. The configuration is sent to the logger through the IR-Link
Interface .
The logger starts and ends the acquisitions according to the
configuration made.
3.1 REGISTER SCREENS
BATTERY SAVING MODE –
IDLE
Low battery consumption mode. The logger does not communicate. It
always stays in this mode after reset; register does not make
acquisitions and does not up-date screen measures. For skipping
idle
mode, press
button for activating communication
temporarily. After an acquisition configuration has been sent, it will
definitely be out of
idle
mode.
Battery Saving Mode
MAIN SCREEN
Indication screen for values measured by the register:
1st Screen – Temperature and
Humidity
2nd Screen – Temperature and dew
point
INDICATOR SCREEN MIN / MAX – CH1
It indicates the minimum and maximum value of Chanel 1 during the
acquisitions.
3rd Screen – CH1 Minimum Value 4th Screen – CH1 Maximum Value
INDICATOR SCREEN MIN / MAX – CH2
It indicates the minimum and maximum value of Chanel 2 during the
acquisitions.
5th Screen – CH2 Minimum Value 6th Screen – CH2 Maximum Value
COMMUNICATION SCREEN IR - COM
It sets IR communication to automatic or manual:
• In the automatic mode (
aut
), communication will be
always active. For communicating, just direct the interface
and use NXperience or LogChart II software. It always
stays in this mode after reset .
•
In the manual mode (
nnan
) communication will be active
20 seconds, after pressing the button. During this
time, a communication shall be initiated for keeping the IR
Communication active.
7th Screen – IR Communication Screens
DISPLAY UPDATING INTERVAL SCREEN -
DISP