NOVUS AUTOMATION
1/9
TagTemp-NFC
TEMPERATURE LOGGER – INSTRUCTIONS MANUAL V 1.0x A
1
I
NTRODUCTION
The TagTemp-NFC is an electronic temperature logger. The sensor
measures this physical quantity and the values are stored in memory.
These data are collected by a smartphone equipped with an NFC
interface (not included).
The LogChart-NFC software enables to set up the equipment
operation mode. It is also used for viewing acquisitions. Other
parameters such as end of measurements, logging interval, etc., are
easily defined through the LogChart-NFC software.
The LogChart-NFC application is targeted to ANDROID™ platform
and must be downloaded from Google Play Store.
2
MECHANICAL INSTALATION
The TagTemp-NFC can be fixed in two ways: by using of screws or
double-sided tape.
For mounting with screws, you should detach the front film of the
equipment carefully, exposing two through holes where TagTemp-
NFC may be screwed, as shown in Fig.1. They should be used M3
flathead screws. When finished, you should stick extra film that
comes with the product to cover again the front of the device.
The other way is to use a double-sided adhesive tape on the back of
the equipment, avoiding placing it above the identification label.
In both cases, the temperature sensor should be placed near the
place where you want to measure the temperature.
Fig. 01 - Mounting holes on the TagTemp-NFC
3
TECHNICAL DATA
Measure Range
Temperature: -40.0 °C to 70.0 °C.
Accuracy
±
0.5 ºC @ 25 ºC.
±
1 °C max. over the full measuring
range.
Note: A measurement error can be
ruled out using the OFFSET parameter
in the LogChart-NFC software.
Measurement
Resolutions
Temperature: 0,1 °C / 0,1 ° F.
Memory capacity
Up to 4020 logs.
Measurement Interval
5 minutes min.
2 hours max.
Supply
2 x 3.0 V lithium battery, built-in, non-
replaceable.
Estimated battery
autonomy
•
Above 300 days – 5-minute logging
interval.
•
Above 400 days – 30-minute
logging interval.
Operating temperature From -10 °C to 70 °C
Dimensions (L x W x H) Main body: 65 x 44 x 8 mm.
RF Interface
ISO 15693 (NFC-V) compatible.
Logger-Smartphone
data transfer time
Approx. 20 seconds (depends on the
smartphone processing speed).
LogChart-NFC
software
Android version: 4.0 or above.
Languages: Portuguese and English.
PC Interface
USB to NFC converter interface
(optional), compatible with LogChart-II
for Windows ®.
Material
Polyamide
Protection
All electronics are protected by the
housing.
