Development and manufacturing of non-
destructive testing units and system
Ultrasonic Tester of Building Materials Strength NOVOTEST IPSM-U
24
9.8. Special operation conditions
9.8.1. Increased dust content and humidity. Put the information
processing unit of device into a transparent plastic bag. Tighten it at
the level of connective cable a bit lower than the probe plug.
After the work under such conditions is finished, information
processing unit shall taken out of the plastic bag and air it.
9
.8.2. Frost (<0°C). Information processing unit is the most sensitive
to low temperature part of the device, especially LCD. If there is a
possibility, keep the device closer to your body and protect it with
your coat or keep in the inside pocket, taking it out time from time for
inputting the data into the archive.
10. Precautions and trouble shouting
10.1. Treat the device with care. Any wrong treatment may result in
the violation of the present Technical Reference and Operation
Manual regulations and, thus, lead to the manufacturer device
warranty cessation.
10.2. Always check the integrity of the cables, Information
processing unit and probes. Provide immediate replacement of the
damaged parts by the original ones. This job shall be performed by
skilled personnel.
10.3. Do not expose the device to aggressive chemical medium.
10.4. Do not leave the device in the direct Sun.
10.5. Do not sink the device into any liquids. If the device gets wet,
take the battery out and leave for 24 hours to get dry. If the device is
used under the increased humidity or dust conditions, place the
information processing unit into the plastic bag. After work period is
over, it is mandatory to get the device dry.
