8
Noventri Eco-Series User Guide
SF-100E-0160-01 REV 03
4.6
Insert the
5V
power connector to the SF-100e using the
AC Adapter
cable
that came
with the SF-100e.
4.7
Your SF-100e should now be ready to use. Verify that the SF-100e is powered
on (LED is glowing green).
4.8
Verify that the monitor is powered on and wait for the Splash Screen to come up. It will
take about 1 minute to fully boot up and display the Noventri Splash Screen along with
the IP Address of the player and the Resolution.
5. Network Usage
5.1
Now that the SF-100e is connected to your network, it needs to be setup to
communicate with the
Noventri Server™
software.
5.2
By default, the SF-100e has DHCP turned on to receive its IP Address automatically.
If the network is setup for DHCP, the SF-100e will be assigned an IP Address.
5.3
If there is no DHCP or the player cannot connect to one, the default IP Address of
192.168.0.190 will be used.
Note:
Make sure that another device on the network is not using the same player’s default
192.168.0.190 IP Address.
5.4
When the SF-100e boots up, it will get an IP Address (DHCP or the default IP Address, if
one is not found). The Noventri Splash Screen will be displayed with the IP Address it will
be using and the Resolution the player is set to. This is a good time to write down the IP
Address for your SF-100e, as you may need to refer to it later.
5.5
If your network is not DHCP and the default IP Address is not compatible with your
network, have your network administrator set up a temporary compatible network. This
will allow you to connect to the SF-100e and change its IP Address to another one that
is compatible with the network you are using.
5.6
Using the IP Address displayed on the Noventri Splash Screen, connect to the
SF-100e using your web browser as you would connect to any website.
Address:
http://192.168.0.190
5.6.1
If you are unable to determine the IP Address of your SF-100e Player, it can be
reset back to DHCP / 192.168.0.190 default. (see
Factory Defaults
section of
this Manual)
