Novellini IRIS dx 600/20, Инструкция по установке, эксплуатации и обслуживанию

Страница: 35 / 60

35
Description of the remote control /30:
Assembly/battery replacement:
Before inserting the batteries, ensure that the power unit is
switched on.
The batteries (supplied) are ALKALINE AAA LR03 1.5V type.
When they run out, they must always be replaced by 2 new
batteries of the same type.
Insert the batteries, being sure to observe the polarity.
NO OK
AAA 1,5V
AAA 1,5V
WARNING: it could be dangerous for
pace-maker wearer. No
pacemakers
Before closing the compartment, check to ensure that the
water-tight seal is still correctly in place.
Description of the remote control:
Once the batteries are inserted, the remote control
searches for the bath with which it will have to communicate.
The bath must therefore be connected to the power supply.
To confirm that this operation has been carried out suc-
cessfully, shortly after the batteries are inserted, the pump
switches on for a few seconds.
Your remote control is now ready to use.
To optimise battery life, the display turns itself off 20 seconds
after the last command entered. To restore it, gently press on
any part of the display.
01- Whirlpool Version with Disinfection
Switching on:
Press the display and hold until the welcome screen appears.
Main commands:
1- Hydromassage
2- Disinfection
3- OFF (all active functions).
Hydromassage menu:
Press button 1 on the main menu to access the
whirIpool massage menu.
2 1
3
Select the hydromassage desired by repeatedly pressing the
relevant button 5.
Press button 6 to confirm and start the hydromassage.
To have the same hydromassage as last time, simply press
button 6 to start
the massage.
To change the duration of the massage, use the duration sub-
menu, which can be accessed by pressing button 4.
AUTOMATIC MANUAL OFF
5
4
6
Hydromassage duration sub-menu:
The + and - buttons can be used to alter the duration of the
massage.
Once the desired time has been entered, press 7 to confirm.
Press 6 if you wish to start the massage.
7
The display shows the remaining hydromassage time; button
8 is lit to show that the massage is in progress.
8
NOTE: If the duration of the hydromassage is set to 0, the
massage will run for about 1 hour, starting from the last com-
mand entered.
If there is not enough water in the bath, the symbol 9 will
appear, at which point you will need to add water to start the
hydromassage automatically.
ENGLISH
9
Whirlpool sub-menu:
Repeatedly press button 5 to select the whirlpool function.
Manual Whirlpool function:
Press and hold button 10 to adjust the intensity of the whirl-
pool massage. Simply release the button to apply the new
setting.
10
Automatic Whirlpool function:
The massage intensity is varied to create a pleasant modu-
lating effect.
You can return from the hydromassage menu to the main
menu using button 11.
11
Disinfection menu:
Press button 2 on the main menu to access the disinfection
menu.
To start disinfection, once the bath has been cleaned, fill the
bath with clean water up to the level used during normal use.
12
13