Novell LINUX ENTERPRISE SERVER 11 - STORAGE ADMINISTRATION GUIDE 2-23-2010, Руководство администратора, Страница: 139 / 140

Documentation Updates 139
no
vd
ocx
(e
n)
7 Ja
nua
ry 201
0
A.6.2 Managing Software RAIDs 6 and 10 with mdadm
The following change was made to this section:
A.6.3 Mass Storage over IP Networks: iSCSI
The following changes were made to this section:
A.7 May 21, 2009
Updates were made to the following section. The changes are explained below.
Š
Section A.7.1, “Managing Multipath I/O,” on page 140
Location Change
Section 7.8, “Configuring Multipath I/O
for the Root Device,” on page 69 Added Step 4 on page 70 and Step 6 on page 70 for System
Z.
Section 7.11, “Scanning for New
Partitioned Devices without Rebooting,”
on page 73 Corrected the syntax for the command lines in Step 2.
Section 7.11, “Scanning for New
Partitioned Devices without Rebooting,”
on page 73 Step 7 on page 73 replaces old Step 7 and Step 8.
Location Change
Section 10.4, “Creating a Degraded
RAID Array,” on page 96 To see the rebuild progress while being refreshed every
second, enter
watch -n 1 cat /proc/mdstat
Location Change
Section 13.3.1, “Using YaST for the
iSCSI Initiator Configuration,” on
page 125 Re-organized material for clarity.
Added information about how to use the settings for the Start-
up option for iSCSI target devices:
Š
Automatic: This option is used for iSCSI targets that
are to be connected when the iSCSI service itself starts
up.This is the typical configuration.
Š
Onboot: This option is used for iSCSI targets that are to
be connected during boot; that is, when root ( / ) is on
iSCSI. As such, the iSCSI target device will be
evaluated from the initrd on server boots.