Novell IDENTITY MANAGER 3.6.1, Руководство по установке

Страница: 82 / 104

82 Identity Manager 3.6.1 Installation Guide
no
vd
ocx
(e
n)
17
Sep
te
m
be
r 20
09
6e On the Driver Configuration page under Startup Options , select Manual , then click OK .
6f Repeat Step 6a through Step 6e for each driver in your tree.
13.3 Adding Files to the Correct Location on
Linux/UNIX Platforms
When you do an in-place upgrade from eDirectory 8.7.3 to eDirectory 8.8.5, the installation places
the eDirectory files in different locations. Because you have Identity Manager installed, eDirectory
will not start unless specific Identity Manager files are in-place. Complete the following steps to add
the files to the correct location:
1
After eDirectory is upgraded to 8.8.5, run the Identity Manager installation with the following
command:
Š
Linux
./idm_linux.bin -i console -DCLUSTER_INSTALL=true
Š Solaris
./idm_solaris.bin -i console -DCLUSTER_INSTALL=true
Š
AIX
./idm_aix.bin -i console -DCLUSTER_INSTALL=true
This adds the correct files without authenticating to eDirectory.
2
Enter
ndsconfig upgrade
to upgrade the eDirectory files.
3 Verify whether the following entry exists in the
nds.conf
file:
n4u.server.interfaces=<ipaddress>@<port>
For example:
n4u.server.interfaces=<ipaddress>@524
If
n4u.server.interfaces
entry does not exist, you should manually set it. To set
n4u.server.interfaces, do the following:
1. Run the following command to find the ncp port:
ndsconfig get "n4u.server.interfaces"
The command returns the ncp port number, for example,
n4u.server.interfaces=@524
2. Run the following command to set
ndsconfig
for
n4u.server.interfaces
:
ndsconfig set n4u.server.interfaces=<ipaddress>@<port>
Where,
<ipaddress>
is the ip address of the machine where eDirectory exists.
<port>
is the ncp port number that you have obtained in Step 1.
For example:
ndsconfig set n4u.server.interfaces=<ipaddress>@524
4 Proceed to Section 13.5, “Upgrading the Metadirectory Engine and Driver Configuration
Files,” on page 83 .