Press Enter and arrow keys to select one of
these options:
Automatic
Manual
Confirmation
This sets the behavior if an assigned sensor
is replaced.
Automatic
: (recommended) In case of
probe replacement the systems assigns
automatically the new sensor in place of the
old sensor.
Manual
: In case of probe replacement the
new probe/sensor must be searched and
assigned manually to the measuring point as
described in Step 1
Confirmation
: (default) In case of probe
replacement the system asks for a
confirmation before assignment of new
sensor in place of the old sensor
Step 3: Assign measuring points and parameters to channels 1 to 4
Analog
Output equals display
line 1
etc.
Enter
Choose Source : Measuring point A to D
Choose measuring point as assigned in step 2 des Messpunktes (A to
D gemäss Schritt 2)
If a channel is not used, the data source it set to "None".
Choose measuring parameter
from measuring point
•
Rel.humidity ( calibration !!)
(rel. Feuchte)
•
Temperature
(Temperatur)
•
Mixing Ratio
(Mischungsverhältnis)
•
Vap. Part. Press.
(Wasserdampfpartialdruck)
•
Dewpoint
(Taupunkttemperatur)
•
Spec. Enth.
(spezifische Enthalpie)
•
Abs. Humidity
(Absolutfeuchte)
Available parameters depend on assigned sensor. Not all parameters
might be available.
Note: the analogue outputs are set-up according to the selected
measuring parameter.
Unit
Measuring unit selection according to the previously selected
parameter.
Press
for Menu
Scroll down
