NOVAK PIT WIZARD, Инструкция по эксплуатации

Страница: 16 / 34

16 PIT WIZARD INSTRUCTION MANUAL
UPLOADING PARAMETERS
FROM CYCLONE
The following steps will allow you to upload the Parameters from
the Cyclone speed control. The values for the Profile (1, 2, 3, or 4)
that is currently active in the Cyclone will be uploaded.
You must upload the values for Neutral, Full Throttle, and Full Brake
that are stored in your Cyclone’s One-Touch memory, otherwise
new/incorrect settings will be downloaded with any new Profile.
1. Turn on your transmitter, then turn on your speed control.
Note: You can use a DSC cord to disable the transmitter’s RF section
(For use at a track/in the pits to avoid interference).
2. Turn on the Pit Wizard’s power switch––slide to ON position.
The display will show the start-up screen:
TEAM NOVAK
PIT WIZARD (rev#)
Note: We recommend that you turn off the Pit Wizard’s power when
not in use to extend the life of the batteries.
3. Connect the Pit Wizard’s D•LINK harness to your Cyclone’s
DataLink socket located on the top of the speed control. The
D•LINK connector can only clear the transistors on the speed
control if the “D•LINK” lettering is right side up. If you have
external heat sinks installed, be sure that they do not extend
beyond the front edge of the transistors––You may need to
reposition heat sinks to gain proper access to the connector.
Note: The motor will be disabled as soon as the Pit Wizard is connected.
**At this time the Cyclone’s LED should be illuminated solid red.
(CONT.)