NOVAK PIT WIZARD, Инструкция по эксплуатации

Страница: 15 / 34

15 PIT WIZARD INSTRUCTION MANUAL
MONITORING TRANSMITTER TRIGGER
This function allows you to monitor the values of your transmitter’s
positions for Neutral, Full Brake, and Full Throttle
(measured in
µ
S) .
This is used to determine if your transmitter has the proper amount
of throw that is needed by your Cyclone speed control.
1. Turn on your transmitter, then turn on your speed control.
2. Turn on the Pit Wizard’s power switch––Slide to ON position.
The display will show the start-up screen as shown on page 15.
3. Connect the Pit Wizard’s D•LINK harness to the DataLink socket
on top of the Cyclone. The D•LINK connector will only clear
the transistors of the speed control if the “D•LINK” lettering is
right side up (Figure 10). If external heat sinks are installed, be
sure that they do not extend beyond the front edge of the
transistors
(they may have to be repositioned to access connector)
.
Note: Motor will be disabled as soon as Pit Wizard is connected. You can
use a DSC cord to disable transmitter’s RF section (To avoid interference).
**At this time the Cyclone’s LED should be illuminated solid red.
4. Press {MODE} button until you reach the Monitor Trigger mode:
6 Monitor Trig
5. Press {ENTER} button to display transmitter’s trigger position:
6 Monitor Trig
1498
µ
S
6. Move transmitter trigger to Full Throttle.
The difference between the Full Throttle and Neutral values
(Drive Throw) should be at least 350
µ
S and up to 550
µ
S.
7. Move transmitter trigger to Full Brake.
The difference between the Full Brake and Neutral values (Brake
Throw) should be at least 350
µ
S and up to 550
µ
S.
IMPORTANT: If you do not get 350
µ
S of Drive AND Brake throw,
your Cyclone will not operate at it’s full potential. You need to
increase your transmitter’s ATV, EPA, or ATL settings to get more throw.
IMPORT
ANT