NovaJet PROe Series
4 Quick Start
Assembling the stand and printer
1
Locate the box containing the printer head and turn it upside down. Open the
box and remove the Setup box which contains the screws and screwdriver to
use for the next steps.
2
Open the box containing the stand and remove the stand and feet from the
box.
3
Note that each foot has two casters, only one of which locks. Attach the feet
to the stand legs, locating the casters so that they are diagonally opposite
each other. Lock the casters to prevent the stand from rolling during subse-
quent assembly.
4
One of the stand legs has a connector on it. Pull the connector from the
access hole in the leg and remove the tiewrap holding the connector in
place. Attach the connector to the connector on the bottom of the print
head. Orient the stand legs so that the roller brackets are facing the center
of the printer head and align with the holes in the bottom of the printer head.
Attach both stand legs to the printer head using the screwdriver and eight
screws contained in the Setup box.
CAUTION: Be careful not to pinch the cable when attaching the leg.
5
Two persons are required to lift the printer. Remove the assembled printer
and stand from the box. Save the boxes and packing materials in case you
ever need to ship the printer.
6
Mount the dryer assembly in the slots provided at the base of the stand. Be
sure fans will blow upward and toward the printer. Position the dryer assem-
bly to the desired angle and tighten the wing nut on the left side.
