Nova Technology International, LLC Standard Profile Truck Lock Series, Инструкция для владельца и пользователя, Страница: 62 / 88

60 Manual No. NT-0-350 - Rev. May 2021
NOVA Truck Lock ™ Standard Profile Manual
1. Entering Maintenance Mode on the Control Box
Key Point: This step can be done on any display or operation except when in HORN OVER-RIDE.
a. Depress the “HORN OVER-RIDE” button (#0 button).
b. The RED light, on the control box, will start flashing if the GREEN light was flashing or remain a constant
RED. This is normal to notify the end user that they are about to enter a new mode.
c. Enter the Maintenance code, 28252, and then press “ENTER”.
i. If the wrong code was entered, the “Wrong PW: Reenter Or wait” display will appear. On this display,
repeat steps 1a through 1c to enter maintenance mode.
ii. Or if no further input is completed within 30 seconds, the “Wrong PW: Reenter Or wait” display will clear
and the screen will return to the previous display.
2. See table below for what display inputs are found on:
Display Information Control Box Display Number
CB-10 CB-11 CB-12
12345678 Inputs 10 11 7
Display Information
—
12345678 Inputs
This display shows all inputs going to the control box. The number zero (0) means the input is off.
The number one (1) means the input is on. The list of all the inputs is listed below:
1. LS1 5. N/A
2. LS2 6. N/A
3. LS3 (OPTIONAL) 7. N/A
4. LS4 (CB-11 ONLY) 8. N/A
TROUBLESHOOTING
LIMIT SWITCH TEST PROCEDURE
CONTROL BOX
CONSOLE FRAME
LIMIT SWITCH 1
LIMIT SWITCH 2
INSIDE OF CONSOLE COVER
LIMIT SWITCH 1
SLIDE POLE
LIMIT SWITCH 2
FIGURE DC — PNEUMATIC TRUCK LOCK ™
LIMIT SWITCH LOCATIONS
FIGURE DD — MANUAL TRUCK LOCK ™
LIMIT SWITCH LOCATIONS