
NM 3000
6
No. 31884 29/05
6 Cleaning
For care of the material, please do not fail to comply with the following important points:
•
Do not use any solvent-containing, caustic cleaning agents!
•
Do not clean devices or instruments with compressed air!
•
Only wipe control unit with cloth. Do not use spray cleaning, as device is not
sealed!
6.1 Motor or handpiece
Æ
See separate instructions for motor or handpiece!
7 Faults and fault detection
Fault: Cause:
Elimination:
Mains connector not plugged
Plug in mains plug
Device does not run:
Wrong operating voltage
Check mains voltage
→
See marking on device label
Foot pedal not connected
Connect foot pedal cable to back of
control unit
Footpedal does not
function:
Control unit not switched on
Switch “ON/OFF” main switch to “ON”
position
Micromotor 31 problems:
See separate operating instructions for micromotor 31
Handpiece 34 problems:
See separate operating instructions for handpiece 34
Handpiece 38 problems:
See separate operating instructions for handpiece 38
If a fault cannot be eliminated, please contact the supplier or the authorised service centre. Relevant
addresses can be found on the last page of the operating instructions.
8 Discarding instructions
When discarding the device, device components and accessories, please comply with the issued
statutory regulations.
With regard to the preservation of the environment old equipment may be returned to the distributor or
manufacturer.
Содержание 306010
Страница 33: ...Anhang Appendi Appendice Appendice Ap ndice ...