Notsi, Ltd., Bulgaria, 9027 Varna, Troleyna 12 street
Ph.: 00359 899 822010; Fax: 00359 52 507227
Web:
www.deltapulse.eu
; E-mail:
Mole LRL 3000D operating manual
7
saved in 5 seconds. If you want to search for another metal, press
Band
once. If
you hold
Band
down for a longer period, the programs shift faster.
Probes –
they should be stuck in a pre-moistened soil by taking them for the top
and bottom caps. Carry out the same actions when taking them out. Handle with
care in order not to damage or break them.
Fuses
- There are three fuses on the front panel – one for each battery. If one of
them burns out, you will not have a frequency on the display or the amplifier
operation will be interrupted. There is a control lamp (Control) next to each fuse
that lights on when the fuse is sound. The fuses are 2.5A.
Waist baguette receiver
- Equipped with a 9V battery. Before each use, press
the button for 3-4 seconds. The brightness of the LED should not change.
Otherwise, replace the battery with a new 9V alkaline one.
CAUTION
1. Mind not to short-circuit the baguettes during operation. They are varnished,
but, still, be careful. This does not apply to the handles that are completely
insulated.
2. Do not change the frequency of operation without waiting for 15-20 minutes.
3. Do not adjust the frequency for the same metal. For example: You have
searched for gold at 5.25kHz and the frequency cannot be immediately adjusted
to 5.5kHz, regardless of the fact that it is also for gold; you should wait for the
technological time.
4. Never short-circuit the probes (PROBE). The short circuit may damage the
entire electronics of the product.
5. Charge the batteries each time you use the locator. When the operation is
over, charge the batteries again. This is required, because the charger is
automatic and the battery needs to have a residual voltage of about 11V in order
to work properly. If you overuse the batteries (not more than 8-9 hours a day),
this voltage will drop below 10V and the batteries cannot be used anymore.
6. Pay attention to the battery status by using the three LOW BATTERY lamps
located on the panel. If the lamps are on, you must charge the batteries.
