Nostolift XS240, Руководство по эксплуатации и техническому обслуживанию

Страница: 28 / 75

®
XS
240
SELF-PROPELLED TELESCOPIC PLATFORM
13.2 CHECKING THE PERMITTED LIFTING RADIUS
The functioning of the limiter of lifting radius depends on the platform load and lifting
radius. The limiter is activated if the platform load is too heavy to start with, if the telescope
or the jib are too far extended, or if the raising movement has gone to the limit. See Boom
geometry.
13.3 CHECKING THE REACH OF TELESCOPE
Figure 12. Checking the reach of telescope
Check the functioning of the safety limits of the lifting radius as follows: with an empty
platform, run the telescope out with the jib extended straight until torque control cuts the
movement. Make sure that the painted mark on the middle boom is visible (see figure 12).
This is the way to verify the functioning of the safety limit of telescoping and at the same
time the permitted lifting radius of the empty platform and extended jib. The maximum
permitted lifting radius from the turning centre to the edge of the platform is 12.3 m.
Alongside the actual safety limit, on the right side of the telescopic cylinder when seen
from the platform, there is also an electronic safety limit for the farther, i.e. higher lifting
radius, which interrupts all movements. This safety limit is activated when the safety limits
permitting a lifting radius in accordance with the Boom geometry diagram are out of the
adjustments or faulty. In normal conditions, the electronic backup safety limit is not
27