E
N
G
LI
S
H
7
Assembly of Storage Compartment
1.
Attach Push Handle (E) to inside of Storage Compartment
(C) using two #9 Screws and two #10 Nuts.
2.
Attach Magnet (N) to inside of Storage Compartment door
opening using two #1 Screws and two #10 Nuts.
Assembly of Concession Stand Tier and Base Support
1.
Attach bottom of Concession Stand Tier (O) to Bottom Plate (J) with two #11 Screws.
NOTE:
Battery for lighted Concession Stand is located on the bottom side of the
Concession Stand. When replacing the AA batteries, be sure polarity is correct (i.e.
match (+) end of battery to (+) end of battery pack) or steps will not light.
2.
Insert Cross Bar (K) into the square inserts on the inside of Base Support (I)
and secure from below with two #2 Bolts. Place the Leg Assembly (L) over the
protruding ends of the Base Support (I) and fasten from the inside of Base
Support (I) using four #4 Bolts, four #5 Flat Washers, and four #8 Nut Caps.
