ENGLISH
7
BUILT-IN WATER TANK
To take advantage of portability, you can use the built-in water tank. Filling it is
simple - open the door on the side of the machine and pour in water.
NOTE
: Make
sure Water Tank Plug is plugged on bottom to ensure water doesn't drain.
NOTE
: Keep the water level below the MAX level mark. If water levels exceed the MAX level mark, drain
any excess water by removing the water drain plug. To maximize ice cube capacity, use cold water.
BEFORE FIRST USE
1.
Follow the steps under CLEANING & MAINTENANCE before using this unit.
2.
Place the unit on a flat, level surface in a location that is protected from
direct sunlight and other sources of heat (i.e. stove, furnace, radiator). Ensure
there is at least four inches of empty space on all sides of the unit.
3.
Allow one hour for the refrigerant fluid to settle before plugging
the cord into an electrical outlet for the first time.
4.
If you decide to use the direct water hookup, see directions at top of page on how to install.
USING YOUR ICE CUBE MAKER
1.
Open the door on the side of the unit and pour water into the Water Reservoir (if you decided to
use direct water line, see directions above). Keep the water level below the MAX level mark.
2.
Press the ON/OFF button on the LED Control Panel to begin the ice-making cycle.
NOTE
:
Once started, you cannot press the ON/OFF button again to stop it. You must wait 30 seconds
to allow the unit to melt the unfinished ice cube. Also, while unit is running, you can press
the ON/OFF to turn it off, but you cannot press the ON/OFF immediately to restart unit - you
must wait 1 minute to allow unit to get back into position while protecting compressor.
3.
Select the desired size of the ice cubes by pressing the SMALL or LARGE button
on the control panel. The S or L will light up on the LED display.
4.
Each ice-making cycle is about 10 minutes, depending on the size of the ice cube selected
and the ambient temperature of the room. In extremely hot temperatures, ice-making time
may vary considerably. While the ice maker is on, check the water level periodically. If the
water pump is unable to pump water, the unit will stop and the Low Water Alarm will sound
and the Water Faucet icon will appear in the control panel, letting you know to add water.
5.
Repeat steps to continue to make ice and once there is enough ice in the ice bin, you
can start to use the dispensers. There are three options: Ice, crushed ice and water.
6.
To dispense ice, place your cup under the right dispenser and push the ice cube dispenser
button in the back to get ice. Let go of the dispenser button when you want it to stop.
NOTE
: When dispensing Ice, a picture of ice will illuminate on the control panel.
7.
The unit automatically stops working when the Ice Basket is full and
the ICE FULL light will illuminate on the control panel.
8.
To ensure a reasonable hygiene level, change the water in the Water Reservoir every
24 hours. If the unit isn’t in use, drain all water left in the Water Reservoir.
IMPORTANT NOTE:
In the event that the power is disconnected during the ice making cycle or that the
LED lights on the Control Panel are blinking, press the ON/OFF button to stop the ice making cycle. Unplug
the unit from the electrical outlet. Allow the unit to sit for a few minutes to let it warm up and allow ice to
Содержание Igloo ICEBDS33SS
Страница 3: ......
