Nostalgia Electrics Igloo ICEBDS33SS, Инструкция и рецепты

Страница: 10 / 28

ENGLISH
8
fall from the evaporator fingers. Empty the Water Tray and wait three minutes before restarting the unit.
DO NOT touch the Evaporator while the unit is in use or during the ice making process. This
could cause severe burns.
USING YOUR CRUSHED ICE MAKER
To get crushed ice, place cup under left dispenser and push the Crushed Ice button the control
panel. That will begin crushing ice. When you want it to stop, push the Crushed Ice button again.
NOTE : When dispensing Crushed Ice, the Crushed Ice picture will illuminate on the control panel.
USING YOUR WATER DISPENSER
To dispense water, place cup under the left dispenser. Push the water dispenser button
in the back to get water. Let go of the dispenser button when you want it to stop.
NOTE : When dispensing water, the Water Dispenser picture will illuminate on the control panel.
HELPFUL TIPS
ADD WATER INDICATOR
If the ADD WATER Indicator comes on, try the following:
• Turn off the unit, add water, and press the ON/OFF button again to restart the unit.
• There may be too much ice. Turn off the Ice Maker, remove some ice from the Ice Basket.
ICE CUBES STICK TOGETHER
• The ice cycle may be too long. Stop the Ice Maker, then restart it when the ice
cubes melt. Select the smaller sized ice cubes using the SELECT button.
• The water temperature in the Water Resevoir may be too low. Change the water in
the Water Resevoir. The room temperature should be set between 45˚ F - 90˚ F.
ICE MAKER NOT WORKING
If the ice-making cycle seems to be running properly, but no ice is being made, try the following:
• The ambient temperature or water temperature in Water Resevoir may
be too high. The unit must be in an environment below 90˚ F. Try pouring
colder water (between 45˚ F - 90˚ F) into the Water Resevoir.
• If changing the water or allowing the unit to cool does not work, there may
be a leakage of the refrigerant fluid, or a pipe in the cooling system may be
blocked. Please take your ice maker to a qualified technician for repair.
CLEANING & MAINTENANCE
Your DISPENSING ICE MAKER & CRUSHER should be cleaned before storing.
Following these steps will help to maintain the unit and add to longevity.
1. Unplug the unit from the electrical outlet.
2. Clean the interior and exterior of the unit using warm, soapy water, and a non-abrasive towel.
3. Drain the interior water by unplugging the Water Drain Plug on the bottom of the unit.
4. Dry the interior and exterior with a soft, non-abrasive cloth.
5. If the unit has not been in use for a long time, always open the Water Drain
Plug and completely drain the water from the Water Reservoir.
AUTO CLEAN
Plug the unit in and add water to the water tank. Press the ON/OFF button for 3 seconds
and then the machine will start auto cleaning. This will take approximately 4 minutes.